Reply to thread

Message: <blockquote data-quote="Clone" data-source="post: 90656" data-attributes="member: 13049"><p>I bought my LX565 knowing it was very jerky a couple weeks ago. I fixed ~90% of the jerkiness with new plastic guides on the front of the centering plate, but I can't seem to get the last 10% figured out. The clamps on top of the pumps are tight, the rollers are intact and look good and no play in the linkage. The only play I can find is in the hinge points of both sticks. Could this cause these problems? The dampers seem okay (they aren't leaking) but I haven't unhooked them yet to stroke without linkage. Any ideas to make this a completely smooth machine again? Also I'm leaking oil from the top of the pumps just below the clamps. Can this seal be changed out without removing the pumps? It looks like a plate could be holding the seals down with some little torx screws if I remember right. I'm thinking I need item 28 while looking at Messicks on the front pump?</p></blockquote><p></p>