Reply to thread

Message: <blockquote data-quote="Fishfiles" data-source="post: 37849" data-attributes="member: 782"><p><a href="https://www.skidsteerforum.com/DesktopDefault.aspx?tabid=52&gallerypage=0&path=valve%20seals" target="_blank">http://www.skidsteerforum.com/DesktopDefault.aspx?tabid=52&gallerypage=0&path=valve%20seals</a>        I went to the media /photos and  on the 3rd page  the last pictures was the ones above , so I thought that had to be you , I looked again and never did find anything that could seem to fit your app. -----------  it could be warped and possibly straightened out , as Tazza said  use a good straight end and a feeler gauge to see if you can see any low spots , if so  then lap it flat , also a crack is possible , a machine shop could possiblly magnaflux it for you , or you can do it your self , I use to have to do it to crane block hooks all the time , you spray cleaner , then a penetranting dye and then a over coat that if there is a crack it will bleed thru the white stuff and show up , only thing is it might be cracked in a spot that you can't see internally ,have seen a few 7 series Bobcats crack the vavle internally and not leak externally but give you fits trying to troubleshot problems from internal pressure going to the wrong place ,  the three cans of magnaflux are expensive though ------------- did you check to see if the bank ( section) is available and how much it cost</p></blockquote><p></p>