Codes

[DNT]

I have a 2006 T 300. I had it in the shop and they replaced the hydrologic filter and repaired a pintail shaft seal leak. They also replaced the tracks. I was told they flashed the controller / updated the program. Now on day one I keep getting code 10-17 day two I get code 10-16 day 3 machine keeps shutting down on cade34-04. I have looked for water in the electrical connections under the cab as the dealer mentioned. Please help, low on cash after the repairs. I don’t want to have to take it back in. I am just a weekend warrior

 

[Bobcatdan]

10-16 and 10-17 are both codes for the hydraulic charge filter, not being connected and plugged. Both are probably caused by the same electrical problem. The 34-04 is lost communication between delux dash and main controller. Look for problems with wires 9220 and 9210.

 

[DNT]

10-16 and 10-17 are both codes for the hydraulic charge filter, not being connected and plugged. Both are probably caused by the same electrical problem. The 34-04 is lost communication between delux dash and main controller. Look for problems with wires 9220 and 9210.

Bobcatdan I think I am on to something. I took the deluxe controller apart. It appears something is loose /bad solder joint. When I move or touch the top board the machine turns off. I will have someone look at it under a scope