Reply to thread

Message: <blockquote data-quote="round2it" data-source="post: 37679" data-attributes="member: 3464"><p>I had a valve on the work piece, Dozer Blade, so I just used another switch, cut the wires to the solenoids and routed 12v directly to the solenoid and switch, the speed is controlled by the throttle valve on the work piece. I have not had any problems. Some of the newer machines do not have the slide switch but instead use momentary push button switches. You should be able to purchase these and if you have enough room on the joy stick just drill holes and install them routing the wires to the solenoid. Good luck</p></blockquote><p></p>