Reply to thread

Message: <blockquote data-quote="greenbuggy" data-source="post: 128270" data-attributes="member: 17524">Following this up:The TAG number showed in the operations manual is no good, it's actually a TA6 pump (apparently the TA6 was separate pump/motor and the T66 pump was a combined unit) and according to parts dept at my local Case non-ag dealer its a TA6-50A-11-511 pump.2 places I found that sell reseal kits for these, Proactive fluid power in Michigan and Hydrostatic transmission service in Mississippi.When I took mine apart (even more than it was already) found some worn out needle bearings - though the case parts book shows them to be different part numbers for the pintle and main shaft, all of mine were Torrington B-118, which crosses to the same Koyo number, readily available on eBay and Amazon inside of $7/ea shipped.  Manual shows the pintle support ones as having to be driven in to a specific depth, would have been nice if Vickers would have machined a step for them to seat against.Main ball bearing is a 6204ZZ (dual metal shield), found a few SKFs on eBay for a little over $9 ea shipped.Tried to get the service manual recommended sealant - Permatex Super 300 - from my local Napa, only one store in the country had it according to my local store when I tried to get it and that store said they didn't have any IRL when I tried to order it.  Found some on eBay for under $12 shipped.In process of rebuilding/resealing the first pump now.</blockquote>