Hello all, I'm new here but I have a 2014 C238 CTL with about 400 hours on it. I'm a wildlife biologist so I use many different machines throughout the year hence the low hours. I am trying to run a fecon mulching head that I've used many times but not recently. When I flip the high flow switch the light won't come on and I can't hear the pump engage like normal. The fuse is good and the switch has power to it. What should I check next? Hydraulic fluid filter? Thanks!
C238 High flow hydraulic problems
- Thread starter wildlife7
- Start date
flyerdan
Well-known member
- Joined
- Mar 7, 2009
- Messages
- 983
Not familiar with the machine, but I would suspect that there is a relay not doing its job somewhere.
I'd suggest sourcing a wiring diagram somewhere and tracing it out, after of course checking any relays in the fuse panel. Often they just have a bit of corrosion that can be solved by pulling them and reseating them.
I'd suggest sourcing a wiring diagram somewhere and tracing it out, after of course checking any relays in the fuse panel. Often they just have a bit of corrosion that can be solved by pulling them and reseating them.
