Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bushings on Bobtach plate
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="bobbie-g" data-source="post: 29481" data-attributes="member: 26"><p>Have the Bobtach plate removed from my T180. I have new tapered pins to replace the ones at the bottom of the plate (one on either side). The parts breakdown does not indicate a bushing inside the lower piviot points on the Bobtach plate. Yet I can see there are bushing inserts there. Anyone have any experience with replacing these bushings? I can just reassemble the thing and leave the slop which won't really hurt anything, but is there a way to replace the bushings? One of the bushings is seated flush with the housing, the other protrudes a bit over 1/8". When I removed the plate, there was no side-to-side freeplay between the lift arms. I now have new grease seals, plus the metal "dust shields" that presumably protect the grease seals (the dust shields were missing from the pins when I removed the Bobtach plate). I don't think there's room between the lift arms to put the metal shields in, unless I cut off the protruding bushing back to flush with the Bobtach housing. Ideas? ---RC</p></blockquote><p></p>
[QUOTE="bobbie-g, post: 29481, member: 26"] Have the Bobtach plate removed from my T180. I have new tapered pins to replace the ones at the bottom of the plate (one on either side). The parts breakdown does not indicate a bushing inside the lower piviot points on the Bobtach plate. Yet I can see there are bushing inserts there. Anyone have any experience with replacing these bushings? I can just reassemble the thing and leave the slop which won't really hurt anything, but is there a way to replace the bushings? One of the bushings is seated flush with the housing, the other protrudes a bit over 1/8". When I removed the plate, there was no side-to-side freeplay between the lift arms. I now have new grease seals, plus the metal "dust shields" that presumably protect the grease seals (the dust shields were missing from the pins when I removed the Bobtach plate). I don't think there's room between the lift arms to put the metal shields in, unless I cut off the protruding bushing back to flush with the Bobtach housing. Ideas? ---RC [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bushings on Bobtach plate
Top