Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 26783" data-attributes="member: 82">Sorry, i don't have any piccies but see if you can work it out from these:1.125" hex, thats measures from flat to flat the slot cut in it is .58" wide and .373" deep. The hole for the pin is .9" up from the bottom of the cut and is 1/2" diameter. The whole "pin" is 3.89" long. One end is the hex, the other is machined down to .8" and is 2.175" long to the shoulder of the hex.I hope that makes a bit of sense.... You have an idea in your head of how it looks, if i missed anything just tell me and i can try and work it out for you.Wedge pin diameter is 1.21, 230mm long. The square plate on the end is 1" wide, 1/2" thick 1.5" long, 1/2" down from the top is a .53" hole in the middle. Hopefully thats enough to get you out of trouble.</blockquote>