Reply to thread

Message: <blockquote data-quote="Fishfiles" data-source="post: 72062" data-attributes="member: 782"><p>I just looked at the pic again and I think it looks like the O.D. of the hub around the outer end of the new weldment looks to be the right size but the O.D. of that new one behind the hub looks smaller than whats on your Bobtack , if so when you go to weld that in there is going to be a big gap along the lengthwise weld , what you think ???? ----if it were you could always lay a piece of flat bar over the gap and weld it on both sides</p></blockquote><p></p>