Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobtach Lever Handle sloppy Fit to bushing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="JimH" data-source="post: 120503" data-attributes="member: 21577"><p>On my T190, I'm tuning up things in the tilt and bobtach area. I notice that the welded-in bushing protruding from the bobtach mounting plate through the lever handle is less than 5/8 inch diameter while the hole in the lever handle is over 3/4 inch. It can only be seen when the handle retaining nut and spring are removed. My question is, should there be this much slop in the handle to bushing? It is a power bobtach and seems to work fine.</p></blockquote><p></p>
[QUOTE="JimH, post: 120503, member: 21577"] On my T190, I'm tuning up things in the tilt and bobtach area. I notice that the welded-in bushing protruding from the bobtach mounting plate through the lever handle is less than 5/8 inch diameter while the hole in the lever handle is over 3/4 inch. It can only be seen when the handle retaining nut and spring are removed. My question is, should there be this much slop in the handle to bushing? It is a power bobtach and seems to work fine. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobtach Lever Handle sloppy Fit to bushing
Top