Reply to thread

Message: <blockquote data-quote="thwerench" data-source="post: 119066" data-attributes="member: 21534">Hello again, it seems like things are returning to where I started on this, after lifting the cab I seen the two rods traveling from the levers back to the hydraulic motors and loosened the 2 3/8 bolts where they slide, I set the at rest point of the levers in the center again, [ there are two switches near the base of the levers, I adjusted those rods to where the levers are not quite touching the switches, is that right?], after my adjustment the travel felt right again both forward and reverse, and the machines forward speed returned to normal as did reverse, but now, after using it the lever travel is slowly progressing towards reverse again, I'd say 1/3 forward to 2/3 reverse.Some how the at rest point of the levers is moving and I don't know why or where, any ideas or feed back would be greatly appreciated, as stated before, the machine moves and works as it should, all hydraulics are fine, lift, tilt, steering, everything is as it should be except the pivot point of the levers is moving towards reverse, my S-650 travels way to fast in reverse and not fast enough forward, I need help, please.Steve</blockquote>