Reply to thread

Message: <blockquote data-quote="Kitt" data-source="post: 74440" data-attributes="member: 5778"><p>Hey guys, I have a fuel shutoff solenoid issue.... 1. Solenoid works when hooked up to 12V supply 2. Voltage of two leads coming into solenoid is 0.2V (+) and Ground (-) 3. I have schematic for my 864 and it shows that it is receiving power from hydraulic filter harness. 4. I have read all sorts of required voltage, but the book shows the Hydraulic sensors put out 0.5V or 7.5V (open, closed?) I did recently fix a hydraulic leak, so there is a chance the pressure was low, but did not get any "dummy" lights. Any recommendations or experiences that could help me find the reason behind the 0.2V instead of 7.5V coming into the solenoid?? short of pulling off all my wire loom and looking for broken wires, I am looking for any additional info. The damn bobcat schematic doesn't even give me wire colors!!!! Thanks in advance for your help!</p></blockquote><p></p>