Visit our tractor and agricultural equipment communities:

Ingersoll Forum Case IH Forum Combine Forum Hay Forum

JCB Forum John Deere Forum Kubota Forum Mahindra Forum

Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum

Zetor Forum Farming Forum

Reply to thread

Help Support SkidSteer Forum:

Message: <blockquote data-quote="igor2009" data-source="post: 92447" data-attributes="member: 13275"><p>01-16 is not connected air filter 01-17 clogged air filter 02-16 Filter hydraulic / hydrostatic system is not connected 02-17 Filter hydraulic / hydrostatic system is connected 03-09 Low battery voltage 03-10 High Voltage Battery 03-11 Extremely high voltage battery 03-14 Extremely low battery voltage 03-22 Battery voltage is below the limit 04-09 Low levels of engine oil pressure 04-14 Extremely low levels of engine oil pressure 04-15 Engine oil pressure at the level of the emergency engine shutdown 04-21 Engine oil pressure above the maximum permissible 04-22 Engine oil pressure below the limit 05-09 Low supply pressure in the hydraulic system 05-10 High charge pressure in the hydraulic system 05-11 Extremely high charge pressure in the hydraulic system 05-14 Extremely low supply pressure in the hydraulic system 05-15 charge pressure in the hydraulic system at the level of the emergency engine shutdown 05-21 charge pressure in the hydraulic system above the maximum permissible 05-22 charge pressure in the hydraulic system below the limit 06-10 high engine speeds 06-11 Extremely high engine speed 06-13 No engine speed signal 06-15 Engine speed at the level of the emergency engine shutdown 06-18 Engine speed is out of range 07-10 Heat the oil in the hydraulic system 07-11 Extremely high temperature hydraulic oil 07-15 The oil temperature in the hydraulic system at the level of the emergency engine shutdown 07-21 The oil temperature in the hydraulic system above the maximum allowable 07-22 The oil temperature in the hydraulic system below the limit 08-10 High engine coolant temperature 08-11 Extremely high engine coolant temperature 08-15 Engine coolant temperature at the level of the emergency engine shutdown 08-21 Engine coolant temperature is higher than the maximum permissible 08-22 Engine coolant temperature is below the limit 09-09 Low fuel level 09-21 Fuel level above the maximum permissible 09-22 Fuel level below the limit 10-17 clogged hydraulic filter discharge 11-05 frame sensor security shorted to battery 11-06 frame sensor security shorted to ground 12-21 Signal ShIMkontrollera front ext. hydraulics for the upper limit of the range 12-22 ShIMkontroller front ext. hydraulics for the lower range 12-23 ShIMkontroller front ext. Hydraulic not in the neutral range 13-05 Retaining fuel cutoff solenoid shorted to battery 13-06 Retaining fuel cutoff solenoid shorted to ground 13.7 Open circuit solenoid fuel cutoff 14-02 retracting solenoid fuel cutoff, the erroneous inclusion 14-03 retracting solenoid fuel cutoff, erroneous shutdown 15-02 retracting solenoid lock rods, erroneous inclusion 15-03 retracting solenoid lock rods, erroneous shutdown 16-05 Retaining solenoid lock rods shorted to battery 16-06 Retaining solenoid locking rod is closed to ground 07.16 Break the chain holding the solenoid lock rod 17-05 hydraulic solenoid shut-off valve is closed to battery 17-06 hydraulic solenoid shut-off valve is closed to ground 17-07 Open circuit hydraulic solenoid shut-off valve 18.05 The solenoid slide is closed to battery 18.6 Solenoid spool is closed to ground 18-07 Open circuit solenoid spool 19-02 solenoid positioning bucket erroneous inclusion 19.3 Solenoid bucket positioning, incorrect shutdown 20-02 Solenoid switching speeds erroneous inclusion 20-03 Solenoid switching speeds, erroneous shutdown Glow plugs 21-02, the erroneous inclusion 21-03 Glow plugs, faulty shutdown Starter 22-02, the erroneous inclusion Starter 22-03, erroneous shutdown 23-02 Rear base solenoid erroneous inclusion 23-03 Rear base solenoid erroneous shutdown 24-02 Rear spindle solenoid erroneous inclusion 24-03 Rear spindle solenoid erroneous shutdown 25-02 Rear auxiliary proportional solenoid erroneous inclusion 25-03 Rear auxiliary proportional solenoid, faulty shutdown 2.26 The erroneous inclusion of the front base solenoid 3.26 Erroneous off the front of the base of the solenoid 27-02 erroneous inclusion of the stem of the front solenoid 3.27 Erroneous front off the stem of the solenoid 28.2 Solenoid relief valve, faulty switch 28.3 Solenoid relief valve, faulty shutdown 29.2 Solenoid large supply, faulty switch 29.3 Solenoid large supply, faulty shutdown 30-28 Failure memory controller 31-28 Fault recovery mode (also appears after the software update) 32-04 Advanced Management (ACS) does not communicate with the controller Bobcat 32-23 Calibration required ACS 32-24 Calibrate ACS 32-31 Fault actuator tilt ACS Other Codes HERE http://truck-manuals.jimdo.com/bobcat-fault-codes/</p></blockquote><p></p>

Verification