Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 19067" data-attributes="member: 82">I was sure the pins would clear the engine and radiator, i just did mine and i thought it was all clear.The best way with the pins is to use a piece of 1 1/4" bar to knock the pins out, this way you don't need to align anything simply knock the pin in backwards. If you cut the bar to the same as the pin just knock it in the same way and the temp pin will be pushed out too. As you want to clean the hole out you can knock it in far enough to hold the arm then clean the hole. I personally would change the grease nipples then pump in good grease taht will push the old crud out.Sorry i don't know how you can get to the 45 degree ones...Have you tried a BIG hammer and a good sized punch? i'm talking like 1" piece of steel stock not a pin punch. A punch can't transfer all the energy to the pin.</blockquote>