Good evening everyone. I'm looking for some help here. I have a Bobcat T300 (around 2006) and just bought a used Bobcat 90 dozer blade for it. The dozer has had the wiring harness replaced with what looks like a skid steer genius harness. I have never needed the electric attachment plug before.
I tested the machine side auxiliary power plug and have power. However, the machines 14 wire harness has been replaced with a 7 wire.
When I power the right thumb switch the blade moves left and right but also tilts up and down. Is the solenoid leaking by? Also, I cannot make the blade tilt up and down with any of the other controls.
The guy said the dozer had not been used in years. So I guess my questions are
1. Do I have a bad solenoid?
2. How should I test this?
3. Is the replacement harness an issue?
4.What/where do I find what all the buttons control on the joysticks?
The machine is hand and foot controls and serial number is 521912235. I apologize if this isn't clear. I'm new and know enough to do a bit of everything but am by far an expert in any of it. Any help is appreciated.
I tested the machine side auxiliary power plug and have power. However, the machines 14 wire harness has been replaced with a 7 wire.
When I power the right thumb switch the blade moves left and right but also tilts up and down. Is the solenoid leaking by? Also, I cannot make the blade tilt up and down with any of the other controls.
The guy said the dozer had not been used in years. So I guess my questions are
1. Do I have a bad solenoid?
2. How should I test this?
3. Is the replacement harness an issue?
4.What/where do I find what all the buttons control on the joysticks?
The machine is hand and foot controls and serial number is 521912235. I apologize if this isn't clear. I'm new and know enough to do a bit of everything but am by far an expert in any of it. Any help is appreciated.
