Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 873
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mmsllc" data-source="post: 93100" data-attributes="member: 13117"><p>I think that the fuel pick up tube is hidden underneath of the hydraulic pumps. On the 863's that I've replaced in the past, I had to remove the right rear tire (optional) & the small inspection cover that bolts in place with two bolts. After doing that, you can lay a light inside to better trace the fuel supply hose to a right-angled fitting. Find the squeeze bulb on the fuel lines just inside the rear engine door. Follow that forward to where you should find that fitting. What I did was simply cut that hose free from that fitting, then sprayed some lube on the fitting & on the grommet that it passes through. Then clamped that fitting tight as hell with vice grips. Twist & pull it straight up. Replace the draw tube & reassemble.</p></blockquote><p></p>
[QUOTE="mmsllc, post: 93100, member: 13117"] I think that the fuel pick up tube is hidden underneath of the hydraulic pumps. On the 863's that I've replaced in the past, I had to remove the right rear tire (optional) & the small inspection cover that bolts in place with two bolts. After doing that, you can lay a light inside to better trace the fuel supply hose to a right-angled fitting. Find the squeeze bulb on the fuel lines just inside the rear engine door. Follow that forward to where you should find that fitting. What I did was simply cut that hose free from that fitting, then sprayed some lube on the fitting & on the grommet that it passes through. Then clamped that fitting tight as hell with vice grips. Twist & pull it straight up. Replace the draw tube & reassemble. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 873
Top