Bobcat 873 Turbo - No Lift, No Tilt

[FAIA]

Hello. My 873 Bobcat is flashing 2 flashes on the right side of the Left controller. I have no lift or tilt. In order to try to fix the problem myself I checked the fuses and cleaned them. Power washed the area under the lifted seat and power washed the engine too. I can't seem to find the problem. Any ideas?

 

[Tazza]

Does the engine bog down at all when you try and lift/tilt? or are the pedals locked out?
Sounds like a bad lockout solenoid to me.

 

[Fishfiles]

what one of the icons are flashing , that will usually point you right at the problem ---------- lock stem coil is probally the most common cause , seat bar sensors' inner plastic bushing broken the second

 

[FAIA]

The engine does not bog down as I have no lift or tilt. After I sit down and power up the bobcat it will at least now have lift and tilt if I just wait for it to go through its sensor test. but if i get in and start up without waiting a few seconds then it won't work at all.

 

[FAIA]

oh, i don't have foot controls, just hand controls.

 

[FAIA]

As I sit in the machine, the hand controller on the left side. It has two LED lights. The right most LED on the left hand controller is blinking 2 blinks.

 

[OldMachinist]

As I sit in the machine, the hand controller on the left side. It has two LED lights. The right most LED on the left hand controller is blinking 2 blinks.

Press and hold the lights button for 2 seconds on the panel with the hour meter. Do any service codes show in the hour meter display?