Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 873 turbo-hydraulics
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Fishfiles" data-source="post: 8087" data-attributes="member: 782"><p>Sounds to me you have a leaking internal seal on one of your drive motors which is filling up your chain case with hydraulic oil ,and there s no oil in the tank and thats way nothing hydraulic is working , there is a plug on the front of the machine about 8inches off the ground , consider it a rear axle plug , when you take the plug out on level ground the oil ( 10-30, 10-40, 15-40) level should be right at the bottom of the threaded hole , if it's over full it is probally the seal of the drive motor , sometimes though water will get in the chain case and float the oil level up higher than the plug , if you are losing hydraulic oil and don't see any leaks it is filling up the case which holds a lot over full , when the chan case is full it will start leaking fron the vent plug on the case cover and the gaskets of the 3 covers that cover the chain case , not too bad a job to repair</p></blockquote><p></p>
[QUOTE="Fishfiles, post: 8087, member: 782"] Sounds to me you have a leaking internal seal on one of your drive motors which is filling up your chain case with hydraulic oil ,and there s no oil in the tank and thats way nothing hydraulic is working , there is a plug on the front of the machine about 8inches off the ground , consider it a rear axle plug , when you take the plug out on level ground the oil ( 10-30, 10-40, 15-40) level should be right at the bottom of the threaded hole , if it's over full it is probally the seal of the drive motor , sometimes though water will get in the chain case and float the oil level up higher than the plug , if you are losing hydraulic oil and don't see any leaks it is filling up the case which holds a lot over full , when the chan case is full it will start leaking fron the vent plug on the case cover and the gaskets of the 3 covers that cover the chain case , not too bad a job to repair [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
bobcat 873 turbo-hydraulics
Top