Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 843 Right Front Wheel Slipping
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="mike_s_82" data-source="post: 101944" data-attributes="member: 3566"><p>Both sprockets look great. I can't see tell full 360 of the rear sprocket but the front looks good. Good teeth. It is a double sprocket that drives the front and rear. It is solid so I don't see anybway one chain could be slipping. I am leaning towards the motor or motor drive shaft. If I recall the motor shaft has a spline on both ends. This is the side that I rebuilt the pump on so it makes that maybe the motor went out. But the chopping sound and the one wheel seemed liked it wasn't moving doesn't seem to match. Once I remove the motor I will know for sure I guess if the rough gear mesh feeling is still there. Just sucks having to pull the pumps. If I pull the pumps I guess I am doing both rear seals and bearings so I don't have to go thru this again.</p></blockquote><p></p>
[QUOTE="mike_s_82, post: 101944, member: 3566"] Both sprockets look great. I can't see tell full 360 of the rear sprocket but the front looks good. Good teeth. It is a double sprocket that drives the front and rear. It is solid so I don't see anybway one chain could be slipping. I am leaning towards the motor or motor drive shaft. If I recall the motor shaft has a spline on both ends. This is the side that I rebuilt the pump on so it makes that maybe the motor went out. But the chopping sound and the one wheel seemed liked it wasn't moving doesn't seem to match. Once I remove the motor I will know for sure I guess if the rough gear mesh feeling is still there. Just sucks having to pull the pumps. If I pull the pumps I guess I am doing both rear seals and bearings so I don't have to go thru this again. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 843 Right Front Wheel Slipping
Top