Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 751 Steering help needed
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="skidsteer.ca" data-source="post: 5510" data-attributes="member: 307"><p>I was able to find one photo here</p><p><a href="http://www.photobucket.com/albums/k293/jlpier01" target="_blank">www.photobucket.com/albums/k293/jlpier01</a></p><p>The round part on the arm that contacts the adjuster block must have come loose. That aluminum arm is known to come loose on the pump too.</p><p>From what I remember its pretty straight forward to take apart.</p><p>Back the centering spring off then remove the plate from the slides</p><p>Remove the arm from the hydro and the linkage and see how bad the arm is worn and if you can tighten it up.</p><p>You will likely have to go through adjusting the square blocks if you change the way any of the parts fit together, the result will be creeping of one or both sides of the machine.</p><p>I can go look this up in my 773 manual to refresh my poor memory if you need it.</p><p>Ken</p></blockquote><p></p>
[QUOTE="skidsteer.ca, post: 5510, member: 307"] I was able to find one photo here [URL='http://www.photobucket.com/albums/k293/jlpier01']www.photobucket.com/albums/k293/jlpier01[/URL] The round part on the arm that contacts the adjuster block must have come loose. That aluminum arm is known to come loose on the pump too. From what I remember its pretty straight forward to take apart. Back the centering spring off then remove the plate from the slides Remove the arm from the hydro and the linkage and see how bad the arm is worn and if you can tighten it up. You will likely have to go through adjusting the square blocks if you change the way any of the parts fit together, the result will be creeping of one or both sides of the machine. I can go look this up in my 773 manual to refresh my poor memory if you need it. Ken [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 751 Steering help needed
Top