Reply to thread

Message: <blockquote data-quote="oracle_of_ferndale" data-source="post: 93702" data-attributes="member: 8577"><p>My 743 had a leak in the same spot. The threads on the fitting were stripped and fluid poured out at the connection - even though I could not see a leak when it was not running. Replaced the fitting with this one http://www.discounthydraulichose.com/product_p/2403lh-10-10.htm. Ground off one end and brazed it on to the cooler. To put a little bit of pressure in the cooler, I capped one end (it takes a -10 jic cap http://www.discounthydraulichose.com/product_p/304c-10.htm) then shot a bit of compressed air in the other side. Hope this helps.</p></blockquote><p></p>