Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Converting to solid state ignition
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Ster1" data-source="post: 122994" data-attributes="member: 20800"><p>You don't need a hoist to pull the engine, but a forklift does come in handy. In any case, the engine and engine bracket come out as one unit. 4 bolts on the bottom of the machine, disconnect fuel, coolant (you gotta drain it) hoses, throttle linkage, exhaust system, disconnect harness plug, remove battery, and just pull straight back. You might need to pry it up a little, but it comes out. Maybe a stack of pallets would help hold it up.</p></blockquote><p></p>
[QUOTE="Ster1, post: 122994, member: 20800"] You don’t need a hoist to pull the engine, but a forklift does come in handy. In any case, the engine and engine bracket come out as one unit. 4 bolts on the bottom of the machine, disconnect fuel, coolant (you gotta drain it) hoses, throttle linkage, exhaust system, disconnect harness plug, remove battery, and just pull straight back. You might need to pry it up a little, but it comes out. Maybe a stack of pallets would help hold it up. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Converting to solid state ignition
Top