Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Converting to solid state ignition
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="RandyL" data-source="post: 121712" data-attributes="member: 20139"><p>OK.... lets see if we can get your plugs wires on correctly. This is an old picture from a previous post that shows it pretty good. This is the Ford 1.6 engine. Mine is wired like this. The cap color does not matter. That is the material it is made of.</p><p></p><p>#1 cylinder is close to you when you open the engine hatch, #4 cylinder is much harder to reach, deep in the engine compartment.</p><p></p><p>There are 2 clips that hold the dist cap on. They are pictured in the drawing. Use them as a guide for installing the plug wires. The clip closer to the engine block should have wires 1 and 2 on either side of it. wires 4 and 3 are on either side of the other clip. Match these wires to the cylinders of the same number.</p><p></p><p>The word counterclockwise refers to the direction the rotor turns when the engine is turning over or running. See how clear all of this is.[ATTACH=full]2581[/ATTACH]</p></blockquote><p></p>
[QUOTE="RandyL, post: 121712, member: 20139"] OK.... lets see if we can get your plugs wires on correctly. This is an old picture from a previous post that shows it pretty good. This is the Ford 1.6 engine. Mine is wired like this. The cap color does not matter. That is the material it is made of. #1 cylinder is close to you when you open the engine hatch, #4 cylinder is much harder to reach, deep in the engine compartment. There are 2 clips that hold the dist cap on. They are pictured in the drawing. Use them as a guide for installing the plug wires. The clip closer to the engine block should have wires 1 and 2 on either side of it. wires 4 and 3 are on either side of the other clip. Match these wires to the cylinders of the same number. The word counterclockwise refers to the direction the rotor turns when the engine is turning over or running. See how clear all of this is.[ATTACH type="full"]2581[/ATTACH] [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Converting to solid state ignition
Top