Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Blown Head Gasket?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="foton" data-source="post: 124379" data-attributes="member: 16041"><p>If you go down the double the gasket route when you have the manfoid off cut them studs off then , and they might be hardened steel so something like a speedy cut will be needed a sawzall might just dance around on them and never get anywhere. It might be kinda a pain but maybe you should look for a different exaust manifold down the road after you make sure the engine is going to be all good, I think your warpage is mostly that and not the head. good luck it will get there.</p></blockquote><p></p>
[QUOTE="foton, post: 124379, member: 16041"] If you go down the double the gasket route when you have the manfoid off cut them studs off then , and they might be hardened steel so something like a speedy cut will be needed a sawzall might just dance around on them and never get anywhere. It might be kinda a pain but maybe you should look for a different exaust manifold down the road after you make sure the engine is going to be all good, I think your warpage is mostly that and not the head. good luck it will get there. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Blown Head Gasket?
Top