Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Blown Head Gasket?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="bobcatzack" data-source="post: 124349" data-attributes="member: 22200"><p>Struggled quite a lot to get the longer than normal studs installed and then the exhaust manifold installed with new gaskets. However, now I can clearly see a thin line of a crack in the middle section of the exhaust manifold where it meets the engine head (pic attached). Surely seem like the exhaust manifold part that attaches to the head is slightly warped! A bit confused now - I would think I will need to remove the exhaust manifold and get the attaching parts resurfaced?? Or would there be an option to use some high-temp gasket sealer? The gap with the two bolts completely tight appear to be about 2mm. </p><p>Thanks!</p></blockquote><p></p>
[QUOTE="bobcatzack, post: 124349, member: 22200"] Struggled quite a lot to get the longer than normal studs installed and then the exhaust manifold installed with new gaskets. However, now I can clearly see a thin line of a crack in the middle section of the exhaust manifold where it meets the engine head (pic attached). Surely seem like the exhaust manifold part that attaches to the head is slightly warped! A bit confused now - I would think I will need to remove the exhaust manifold and get the attaching parts resurfaced?? Or would there be an option to use some high-temp gasket sealer? The gap with the two bolts completely tight appear to be about 2mm. Thanks! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Blown Head Gasket?
Top