Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Blown Head Gasket?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="craigb93" data-source="post: 123863" data-attributes="member: 4541"><p>Remove the bottom plate on the Oil Pump. See if it will turn over so you have a new flat side. Failing that, lap the original side flat with a sheet of wet-dry sandpaper placed a piece of Lexan window pane. The little half-moon wear mark you see will reduce pump performance quite a bit. Just wet it with water as you sand.</p></blockquote><p></p>
[QUOTE="craigb93, post: 123863, member: 4541"] Remove the bottom plate on the Oil Pump. See if it will turn over so you have a new flat side. Failing that, lap the original side flat with a sheet of wet-dry sandpaper placed a piece of Lexan window pane. The little half-moon wear mark you see will reduce pump performance quite a bit. Just wet it with water as you sand. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 632 - Blown Head Gasket?
Top