Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 610 - I have no variable speed (literally!).
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Bobm500Cat" data-source="post: 96233" data-attributes="member: 13757"><p>Hello, New to the forum. Got a Bobcat M500 w/ Duetz F2L310. Found this forum while searching the web looks like a good place to share ideas and get help. From the original poster the parts in the earlier post picture in blue (seals) were trashed in mine. I took a gamble and found a Teflon bushing approx 6mm diameter and 1/2 inch long and shaved it until it fit snugly between the edge of the roto-swivel piece and the plunger. The unit barely works but leaks. I may try to find another solution. As the original poster attempted, I would like to make my sheave functional without leaking. Also, how do you align the sheave pieces? It is again the case of too little information available with detail pictures and I wasn't paying attention when I pulled the piece off. The bobcat site was helpful but real pictures are best. I did my best to align the 'G' stamped the spline edge on both pieces but Im not sure that is correct because they offset each other. |G||G| I apologize if this post departs from forum etiquette, I can create a new thread if required. Thanks.</p></blockquote><p></p>
[QUOTE="Bobm500Cat, post: 96233, member: 13757"] Hello, New to the forum. Got a Bobcat M500 w/ Duetz F2L310. Found this forum while searching the web looks like a good place to share ideas and get help. From the original poster the parts in the earlier post picture in blue (seals) were trashed in mine. I took a gamble and found a Teflon bushing approx 6mm diameter and 1/2 inch long and shaved it until it fit snugly between the edge of the roto-swivel piece and the plunger. The unit barely works but leaks. I may try to find another solution. As the original poster attempted, I would like to make my sheave functional without leaking. Also, how do you align the sheave pieces? It is again the case of too little information available with detail pictures and I wasn't paying attention when I pulled the piece off. The bobcat site was helpful but real pictures are best. I did my best to align the 'G' stamped the spline edge on both pieces but Im not sure that is correct because they offset each other. |G||G| I apologize if this post departs from forum etiquette, I can create a new thread if required. Thanks. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
Bobcat 610 - I have no variable speed (literally!).
Top