Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 17775" data-attributes="member: 82"><p>No slop what so ever! I should try and get a picture for you, its a very simple mod if you have access to a lathe and welder. Operation is smooth, there is just enough tolerance between the pin and the bronze bushing for the grease to run and its super smooth, it may be a little grubby looking when the grease squirts out the sides, but it does the job! Drilling the pin can be a little tough as its hardened. I used a tungsten center drill to start the hole and the same drill for the oil hole 1/2 way down the pin. Once you get through the hardening its ok, it has a reasonably soft center.</p></blockquote><p></p>