Reply to thread

Message: <blockquote data-quote="leaddog" data-source="post: 41768" data-attributes="member: 3336"><p>I got the uhmwp here. http://www.professionalplastics.com/UHMWSHEETRODTUBE It's a plastic that is for high abrasive aplications. I got two tubes 1in x 1 1/2in x 8ft and cut them to lenght. I had to get two and had enough left over for half of the other side. If you want to do both sides get three. I used permatex gasket paste to seal. If the seal areas are oversize you might get by using loctite. Mine were and I used .010 shim stock and loctite and it worked well. A trick i learned in my profession, Machine repair. I didn't have to replace any bogies. I have thought if I have to I will look into machining up some uhmwp for there also. It should hold up well in that aplication also. We used to use alot of it for high abrasive aplications and it holds up great. Does your machine have the pto installed? Mine did and I took it off and put it on a 3pt adapter I made and now can run my snowblower, brushhog, etc. I'll take some pic's when I get a chance and post it in the homemade fourm. It really works nice. Good luck leaddog</p></blockquote><p></p>