anyone Know how to change a Hydraulic Position Pump Sensor | 6687984??? Bobcat S130

[fadawa]

Hello,

Need to change the Hydraulic Position Pump Sensor | 6687984 on a Bobcat S130. Skid steer does not move or lift or do any hydraulic functions. I was told by a machanic that it was this sensor? anyone have a different option or can concur with this sensor being the problem.

 

[brdgbldr]

Hello,

Need to change the Hydraulic Position Pump Sensor | 6687984 on a Bobcat S130. Skid steer does not move or lift or do any hydraulic functions. I was told by a machanic that it was this sensor? anyone have a different option or can concur with this sensor being the problem.

You should be able to find it on the schematic in the parts catalog:

Bobcat Parts Catalog - Find Diagrams for Your Equipment - Bobcat Company

Locate all parts and component information about your Bobcat equipment with detailed visual diagrams and illustrations with parts numbers and add to your list.

partscatalog.bobcat.com

 

[Josh brown]

Did you check the drive belt to make sure it wasn't broke? If you have to change this sensor youll probably have to pull the engine. Its on the bottom of the hydrostatic pump. You may be able to remove butthe hydraulic lines, remove the motor mounts, and jack the engine up to access the swash plate sensor but it usually requires pulling the engine. They dont typically go bad so if make sure this is the problem before you go down that rabbit hole.

 

[fadawa]

Did you check the drive belt to make sure it wasn't broke? If you have to change this sensor youll probably have to pull the engine. Its on the bottom of the hydrostatic pump. You may be able to remove butthe hydraulic lines, remove the motor mounts, and jack the engine up to access the swash plate sensor but it usually requires pulling the engine. They dont typically go bad so if make sure this is the problem before you go down that rabbit hole.

My Skid steer does not move more than a few feet and it shuts down as it the safety bar were lifted. it does not move, hydraulic don't work, just stops and shuts down. took it to shop for, diagnose came to be these sensors but not sure. What else can it be?

 

[fadawa]

My Skid steer does not move more than a few feet and it shuts down as it the safety bar were lifted. it does not move, hydraulic don't work, just stops and shuts down. took it to shop for, diagnose came to be these sensors but not sure. What else can it be? belt drive seems ok. If belt drive, hydraulics would still work?