Reply to thread

Message: <blockquote data-quote="Rotaxxx" data-source="post: 88181" data-attributes="member: 11791"><p>If you don't have a slide hammer like I did when I did my s250 I made a little puller out of a 1/8" pipe nipple, 3/8 bolt and nut and piece of 3/4 angle iron. It popped them out pretty slick. I drilled a hole in the angle iron, put the bolt through the hole with the nut on it already. Stuck the 1/8 nipple on the end of the bolt and welded it there. Then just thread the nipple into the hole, tighten the nut up and it will pull it out. I would take a pic for you but I am away from home.</p></blockquote><p></p>