red56turbo
New member
- Joined
- Oct 8, 2011
- Messages
- 4
I know this has been asked before. I also searched the archives and found a couple good answers. Just wanting to know if someone has any other tricks. I'm trying to put on a new drive belt after rebuilding the driven sheave. Finally got the belt on the driven sheave and over the drive sheave shaft. I can't get the outer half of the drive sheave on far enough. I blocked a piece of wood in the driven sheave, but still can't get the outer half on. In the archives I read the post of putting an 11/16 socket in there. I think abnorml posted it. Trying to figure out how to drive it between the pulleys with the drive belt in the way. Any other trick of the trades out there? I'm open to options or ideas. Thanks in advance!
