Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
All 8 PUSH ROD BENT!!!!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 11098" data-attributes="member: 82"><p>As i stated in your earlier posts it is most likely the timing belt. There was another user that had this happen to them. Changed the push rods and belt, worked great! no permanent damage.</p><p>The timing belt MUST be changed every 1000-1500 hours, i'm not sure of which but it must be done or this can happen. Re-set your timing to TDC, replace the belt and install new push rods. ensure you turn the engine over at least 2 revolutions by hand to ensure the timing is in fact correct. You don't need it to be off a few cogs and bend another 8 rods!</p><p>Its just one of the joys of engines that run timing belts instead of gears or chains.....</p><p>Good luck!</p></blockquote><p></p>
[QUOTE="Tazza, post: 11098, member: 82"] As i stated in your earlier posts it is most likely the timing belt. There was another user that had this happen to them. Changed the push rods and belt, worked great! no permanent damage. The timing belt MUST be changed every 1000-1500 hours, i'm not sure of which but it must be done or this can happen. Re-set your timing to TDC, replace the belt and install new push rods. ensure you turn the engine over at least 2 revolutions by hand to ensure the timing is in fact correct. You don't need it to be off a few cogs and bend another 8 rods! Its just one of the joys of engines that run timing belts instead of gears or chains..... Good luck! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
All 8 PUSH ROD BENT!!!!!!
Top