ahc no codes 2000 963g

[DRTURBO69]

Hello left handle will try to lower bucket-but is allready down will not raise no engine sound differance.Have a manuel doesnt till how it works?Have a 5 volt referance in on 3 wire connector but cant see it go to other wires when handle moved.When changing connectors after controller raise and lower work with other handle.Please till me how this system works? P.S.Getting to not like AHC Thanks in advance.Frank

 

[DRTURBO69]

UPDATE CHECK VOLTAGE CHANGES AT COMPUTER IN SPEC.-ONLEY FUNCTION NOT WORKING IS RAISE-SWITH WIRES OUT ON CONTROLLER-WORKS BUT THEN NO TILT DUMP. CONTROLLER BAD? THANKS FRANK

 

[mrfixitpaul]

UPDATE CHECK VOLTAGE CHANGES AT COMPUTER IN SPEC.-ONLEY FUNCTION NOT WORKING IS RAISE-SWITH WIRES OUT ON CONTROLLER-WORKS BUT THEN NO TILT DUMP. CONTROLLER BAD? THANKS FRANK

Try swapping the connectors for both actuators for the control valve and see if the problem stays with the tilt or moves to the lift...to rule out an actuator or valve problem and maybe point to a handle problem.

 

[DRTURBO69]

Try swapping the connectors for both actuators for the control valve and see if the problem stays with the tilt or moves to the lift...to rule out an actuator or valve problem and maybe point to a handle problem.

Hello switched connectors does work.Have checked voltage inputs at control box -in spec.Does anyone rebuild control boxes.$1175 for new one.any other models same-any used?Part # 6674804. thanks for any leads.Frank