Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
A 743 in pieces
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 24429" data-attributes="member: 82"><p>They should go back in the exact same way they came out. I don't think the dimples matter its the wear they will have now that matters. I use an egg container when working on drive motors, i pill the rollers out and put them in the same way they come out remembering what one starts where, usually a case drain hole then work clockwise. Pull them out and keep them in the same location and same way up.</p><p>They will have a few marks on them and the housing they run in too, its best that they stay the same so you have minimal leakage as they have worn in. Use lots of oil when re-assembling it too.</p><p>Any problems just yell, i have done a few drive motors.</p></blockquote><p></p>
[QUOTE="Tazza, post: 24429, member: 82"] They should go back in the exact same way they came out. I don't think the dimples matter its the wear they will have now that matters. I use an egg container when working on drive motors, i pill the rollers out and put them in the same way they come out remembering what one starts where, usually a case drain hole then work clockwise. Pull them out and keep them in the same location and same way up. They will have a few marks on them and the housing they run in too, its best that they stay the same so you have minimal leakage as they have worn in. Use lots of oil when re-assembling it too. Any problems just yell, i have done a few drive motors. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
A 743 in pieces
Top