Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
873 Drive Motor Question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 49576" data-attributes="member: 82"><p>The carrier stays on the machine. The seal can be replaced without removing it, just take the motor off.</p><p>You will need to locate where the leak is coming from, if the motor is leaking and has excessive back pressure it will push past the seal and into the chain case, not leak outside unless the chain case is over filled. If its doing this, check your case drain filters, if they are plugged the back pressure will push past the seal and into the chain case.</p><p>If you need to remove the carrier, you just cut the chain and install master links or con-links. No need to loosen the axles.</p><p>Did you fill the chaincase to the correct level? to the bottom of the threads of the plug at the front?</p></blockquote><p></p>
[QUOTE="Tazza, post: 49576, member: 82"] The carrier stays on the machine. The seal can be replaced without removing it, just take the motor off. You will need to locate where the leak is coming from, if the motor is leaking and has excessive back pressure it will push past the seal and into the chain case, not leak outside unless the chain case is over filled. If its doing this, check your case drain filters, if they are plugged the back pressure will push past the seal and into the chain case. If you need to remove the carrier, you just cut the chain and install master links or con-links. No need to loosen the axles. Did you fill the chaincase to the correct level? to the bottom of the threads of the plug at the front? [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
873 Drive Motor Question
Top