Reply to thread

Message: <blockquote data-quote="slewpumper" data-source="post: 10213" data-attributes="member: 838"><p>Siduramaxde your are correct I thought it was a 83hp motor but my maintenance manual says its 73. It also says it has a 25 gallon tank, if I run it to empty it takes less then 15 gallons to fill so not sure about that spec. The oil cooler must retain about 7 quarts after the engine is drained because it says it hold 17 qts. When you change it you only add 10qts. Would be nice to get all the oil out. I will have to check with Bobcat about the thermostats. If you have the time just check the 2 oil lines on your T200 when the engine is at operating temp. On mine the one is hot and the other is slightly warm. If this oil is circulating through the cooler properly I would think they should feel about the same. I am checking them right out of the motor, one on the right and the other the left when you open the door. Thanks!</p></blockquote><p></p>