863c error code

[jim863]

just bought this machine and it has a code something 7 and i will have to get the first part of code but it says sensor out of range and the symbol that looks like a drop inside a bulb is flashing. my question is will it hurt if i run it with this code. thank yall for any help you can give me. Oh yea this is a 98 with about 1900 hours

 

[biggie]

Sounds like"hyd oil temp sensor out of range" Not sure low or high.

 

[jim863]

ok i went out and fired her up i am getting two codes one is ep 3 and the other is ep 7. and on my bar gauge it is all the way up. from what i can tell the ep3 code is no wire connection and ep7 is sensor out of range. so will it hurt if i run the machine until i have funds and time to get it checked. or is there anyone in tx hillcountry that might be able to help me out? thank yall for any advice you can give.

 

[hydrostatic]

ok i went out and fired her up i am getting two codes one is ep 3 and the other is ep 7. and on my bar gauge it is all the way up. from what i can tell the ep3 code is no wire connection and ep7 is sensor out of range. so will it hurt if i run the machine until i have funds and time to get it checked. or is there anyone in tx hillcountry that might be able to help me out? thank yall for any advice you can give.

probobly engine oil pressure sensor broke but mostly the harnes conector is no good had some isseu whit it thats the connector in the sensor look if the connectors insid are worn

 

[bbobcat475]

probobly engine oil pressure sensor broke but mostly the harnes conector is no good had some isseu whit it thats the connector in the sensor look if the connectors insid are worn

with the ep7 code and the bar gauge pegged out i would guess your oil pressure sender is internally shorted or the wiring is. i would just unplug the oil pressure sender and see if the code changes. Then put a jumper wire in connector and see if same code comes back. Anytime you run a machine without the gauges working properly you run the risk of damaging the loader.

 

[jim863]

with the ep7 code and the bar gauge pegged out i would guess your oil pressure sender is internally shorted or the wiring is. i would just unplug the oil pressure sender and see if the code changes. Then put a jumper wire in connector and see if same code comes back. Anytime you run a machine without the gauges working properly you run the risk of damaging the loader.

would anyone know the where abouts of that sensor? this is my first bobcat so im trying to learn as much as i can. so any help would be appreciated.

 

[hydrostatic]

would anyone know the where abouts of that sensor? this is my first bobcat so im trying to learn as much as i can. so any help would be appreciated.

open rear door right hand side botom engine mount just above engine mount moulded socket 3 piece conector black with copper 3 bleu cables coming out sorry for the english

 

[jamesjellybean]

just bought this machine and it has a code something 7 and i will have to get the first part of code but it says sensor out of range and the symbol that looks like a drop inside a bulb is flashing. my question is will it hurt if i run it with this code. thank yall for any help you can give me. Oh yea this is a 98 with about 1900 hours