Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
863 problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="westbrooklawn" data-source="post: 31569" data-attributes="member: 2626"><p>I was running my 1997 863 across a mild slope (right side downhill), when the engine started knocking and blowing large amounts of white smoke. It then reved extremely high and would not shut down with throttle or key... I had to lower the bucket and stall it to turn the engine off. I waited a minute, and restarted it, got back on level ground, and it ran fine. Did it one more time in the same spot (right side low). I checked the engine oil, it appeared to be overfilled... ran it with the dipstick out and it was pumping oil out of the dipstick tube. What has happened? I ran it for several hours after that an it seemed fine... power good, etc., but oil still reads way over full. Hydro fluid level is where it should be. Oil seemed too thin to me also... is diesel getting into the oil somehow? Thanks in advance for any help.</p></blockquote><p></p>
[QUOTE="westbrooklawn, post: 31569, member: 2626"] I was running my 1997 863 across a mild slope (right side downhill), when the engine started knocking and blowing large amounts of white smoke. It then reved extremely high and would not shut down with throttle or key... I had to lower the bucket and stall it to turn the engine off. I waited a minute, and restarted it, got back on level ground, and it ran fine. Did it one more time in the same spot (right side low). I checked the engine oil, it appeared to be overfilled... ran it with the dipstick out and it was pumping oil out of the dipstick tube. What has happened? I ran it for several hours after that an it seemed fine... power good, etc., but oil still reads way over full. Hydro fluid level is where it should be. Oil seemed too thin to me also... is diesel getting into the oil somehow? Thanks in advance for any help. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
863 problems
Top