Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
7753 bobcat front hub removal
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Markaldo" data-source="post: 97349" data-attributes="member: 13954"><p>New here so please be gentle.. Lol. My 7753 is leaking oil on the inside of the tire so I would assume it's time to change the axle oil seal.. I pulled the tire, removed the 1 1/2 bolt that holds the hub, removed two wheel lugs and put a puller on it.. ( this is what the manual tells you to do ) cranked down on the puller and this hub does not want to budge!!! Even with a couple of blows from a 8lb hammer.. Nothing!!! Am I missing something? If I grab the hub, pull and push on it there is about 3/8 of an inch of travel back and forth.. Might it need bearings also? Oil seal was only $12 from bobcat but I think I burnt about $100 worth of patience trying to get that hub off.. Any info would be gladly appreciated</p></blockquote><p></p>
[QUOTE="Markaldo, post: 97349, member: 13954"] New here so please be gentle.. Lol. My 7753 is leaking oil on the inside of the tire so I would assume it's time to change the axle oil seal.. I pulled the tire, removed the 1 1/2 bolt that holds the hub, removed two wheel lugs and put a puller on it.. ( this is what the manual tells you to do ) cranked down on the puller and this hub does not want to budge!!! Even with a couple of blows from a 8lb hammer.. Nothing!!! Am I missing something? If I grab the hub, pull and push on it there is about 3/8 of an inch of travel back and forth.. Might it need bearings also? Oil seal was only $12 from bobcat but I think I burnt about $100 worth of patience trying to get that hub off.. Any info would be gladly appreciated [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
7753 bobcat front hub removal
Top