Reply to thread

Message: <blockquote data-quote="Underwoodjd" data-source="post: 76755" data-attributes="member: 10966"><p>The bushings and pins are worn out on the Bob Tach.  I have purchased new bushings and pins.  The tapers are OK so the pin installation easy easy.  The bushings are another matter.  I've read about a couple ways to remove the bushings.  Welding a large nut to the bushing and using a slide hammer or cutting the bushing with a torch.  I think I can get them out.  Looking for advice on installing the new bushing.  Don't have a large press.  Any ideas?</p></blockquote><p></p>