Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Visit our tractor and agricultural equipment communities:
Ingersoll Forum
Case IH Forum
Combine Forum
Hay Forum
JCB Forum
John Deere Forum
Kubota Forum
Mahindra Forum
Massey Ferguson Talk
New Holland Forum
Valtra Forum
Yanmar Forum
Zetor Forum
Farming Forum
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
773 with drive problems
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 18884" data-attributes="member: 82"><p>If its the same a 751 or 763 motors they are very simple. Just ensure you keep it all clean and that ALL the parts go back in the same place. I'd pull it down and check the seals on the back section where the oil comes in. There are a few O rings and backup rings here that hold back the 5000 PSI that the pump generates. I have pulled a motor down that 1/4 of one O ring was gone, it turned to dust. The other 2 had cracked backup rings.</p><p>Seal kits are available from your dealer and i'm sure <a href="http://www.skidloaderpumps.com" target="_blank">http://www.skidloaderpumps.com</a> has them too.</p><p>No special tools are required, use lots of oil when re-assembling it.</p></blockquote><p></p>
[QUOTE="Tazza, post: 18884, member: 82"] If its the same a 751 or 763 motors they are very simple. Just ensure you keep it all clean and that ALL the parts go back in the same place. I'd pull it down and check the seals on the back section where the oil comes in. There are a few O rings and backup rings here that hold back the 5000 PSI that the pump generates. I have pulled a motor down that 1/4 of one O ring was gone, it turned to dust. The other 2 had cracked backup rings. Seal kits are available from your dealer and i'm sure [URL]http://www.skidloaderpumps.com[/URL] has them too. No special tools are required, use lots of oil when re-assembling it. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
773 with drive problems
Top
