Reply to thread

Message: <blockquote data-quote="ozziweb" data-source="post: 61534" data-attributes="member: 8395"><p>Hi there I ran out of fuel the other day and I am having trouble bleeding the air out of the lines. I have searched the forum and thought its easier to ask, I know this has been asked before so sorry for bringing it up again. Primer bulb is hard, I can get it to fire but it blows a puff of black smoke then stalls after 1 second. I thought I located the bleeder knob (assuming its the little nut type knob where the fuel line coming out of the filter is) When I loosen it nothing seems to happen So i took the fuel line off that comes off this bleeder knob (again I only assume this is the knob) and when I pump the bulb I then get air noise coming through the fuel line. Put the smaller fuel line back on, done up the nut, pump the fuel bulb and its hard again. I had this happen once before and I bled it at the injector but buggered the injector up (cross threaded) so I am hesitant to bleed from there. WHen I take the nut off what I assume is the bleeder knob, there is a little pin in the center, could this be stuck in which is disabling fuel to bleed out the other side? Thanks for any assistance.</p></blockquote><p></p>