Reply to thread

Message: <blockquote data-quote="nobull1" data-source="post: 20964" data-attributes="member: 722"><p>I was moving a bunch of snow today for 4 or 5 hours. After I shut off for a couple of hours  I went to start and the traction lock would not release. All the lights were on, on the BICS but nothing would release the brake (no noise) including traction over ride. I looked at the fuses and found a 25 amp that was blown and replaced it but to no avail. The fuse did not blow again by the way. In the end I removed the solenoid and clamped the round pin up and made a rubber gasket to keep the dirt out. It meant I was able to finish the job without delay. Still I have to fix this problem and wondering if anyone has a procedure for checking other than  just buying a new solenoid.</p></blockquote><p></p>