Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
763 Steering Issue - Found Problem
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="TriHonu" data-source="post: 63212" data-attributes="member: 897"><p>To compress the spring before you secure it with Zip Ties, pull the right steering lever to the rear and put a 3/8" spacer between the Pintle Arm Cam ( the short round piece bolted to the aluminum pintle arm) and the block it was resting against.</p><p>Next push the right steering lever forward. The cam with the spacer will now move the steel plate further to the right compressing the spring. You can now place an inch or longer spacer between the top steel plate and the L shaped steel bracket bolted to the top of the pump.</p><p>This will hold the spring compressed until you get the Zip Ties in place.</p><p>Remove the two spacers and remove the bolt holding the spring in place.</p></blockquote><p></p>
[QUOTE="TriHonu, post: 63212, member: 897"] To compress the spring before you secure it with Zip Ties, pull the right steering lever to the rear and put a 3/8“ spacer between the Pintle Arm Cam ( the short round piece bolted to the aluminum pintle arm) and the block it was resting against. Next push the right steering lever forward. The cam with the spacer will now move the steel plate further to the right compressing the spring. You can now place an inch or longer spacer between the top steel plate and the L shaped steel bracket bolted to the top of the pump. This will hold the spring compressed until you get the Zip Ties in place. Remove the two spacers and remove the bolt holding the spring in place. [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
763 Steering Issue - Found Problem
Top