Reply to thread

Message: <blockquote data-quote="Tazza" data-source="post: 63190" data-attributes="member: 82">The way i saw it done was with a few heavy duty cable ties, run it through the top and bottom coils to compress it, i'd use a few to take the load. Remove the nut holding it in place and you are good to go.You can do it without the cable ties, but it's hard to get back in. I had to get my GF to assist by holding a pry bar to compress the spring while i tried to put the nut back on, it took about 15 minutes of trying and a bit of whining from the gf as it was taking too long, but we got there.</blockquote>