Visit our tractor and agricultural equipment communities:

Ingersoll Forum Case IH Forum Combine Forum Hay Forum

JCB Forum John Deere Forum Kubota Forum Mahindra Forum

Massey Ferguson Talk New Holland Forum Valtra Forum Yanmar Forum

Zetor Forum Farming Forum

Reply to thread

Help Support SkidSteer Forum:

Message: <blockquote data-quote="OldNeons" data-source="post: 63063" data-attributes="member: 8642"><p>My 763 C series with Kubota diesel died last week - lost power, idled for about 30 secs then died and wouldnt restart. Today I changed fuel filter, refueled, tried to prime and nothing. Didn't seem to be pulling fuel out of 3/4 full tank. So I disconnected at primer bulb and put hose into a 5 gal jug. Primed properly, started and runs fine. Please don't tell me it's the pickup and I have to pull engine/hydro to access tank? What else can it be? I replaced fuel pump assembly within last year so assuming its ok (especially since it's pulling fuel out of jug). I searched the forum and found reference to a fuel shutoff solenoid and also a "pump to valve hose rubbing through" but am unfamiliar with these. Mine does have a pretty steady hydraulic leak recently - trying to get it running and get into warm shop for repairs.... How can I check/rule these possibilities out. 1) pickup or in tank filter issue? 2) fuel shutoff solenoid? 3) pump to valve hose rubbing through?? 4) other ideas? The post referencing these is from Bobcatdan and is below. Appreciate any input on this. Thanks!!!! 753 Dead, help service manual needed Posted: 10/05/2012 03:47 AM hi guys, my old man recently brought a used 753, it just died yesterday, i've been searching for a workshop manual however had no luck, can anyone help me out ? thanks Tazza is not online. Last active: 2/8/2013 1:27:53 AM Tazza Top 25 Poster Forum Moderator Joined: 08 Dec 2004 Total Posts: 9690 Re: 753 Dead, help service manual needed Posted: 10/05/2012 10:49 AM 753, three guess. Died and don't start, fuel shut off solenod died or fuel pick up tube in the tank rotted off. If it is duming massive amounts of hydraulic fluid, the pump to valve hose rubbed threw. Serivce manuals have next to no dianostic in them other then wiring diagrams an some pressure specs. giang723 is not online. Last active: 10/6/2012 4:29:09 AM giang723 Joined: 05 Oct 2012 Total Posts: 2</p></blockquote><p></p>

Verification