Reply to thread

Message: <blockquote data-quote="crazycat" data-source="post: 35774" data-attributes="member: 2997"><p>Sorry it took so long to post back. I finally had time today to remove the drive motor from th side of the bobcat. I found a tear in the 4-5" diaphram looking seal. I pulled on the rubber part of the seal and it started to come off. It looked like there is a metal plate behind the rubber part. As mentioned above, is this part of the seal that you said I need to drill a hole through to use the slide hammer? If so, is there anything behind the metal plate that will get hurt when I drill the hole? I am going to replace this seal and the rubber O-ring that sits next to the brass bushing on the drive motor, where the drive gear comes out, if that makes sense to everyone. Not sure how to post pics. I took three.</p></blockquote><p></p>