Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753F Spool seal replacement question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Phild58" data-source="post: 112564" data-attributes="member: 19161"><p>Hello members, and thank you for the add. I have a question about the seal replacement on the spool valves for a 753F model. I have managed to disconnect the pedal linkage at the front of the valve block (PITA job because the clevis pin was in backwards and I couldn't remove it without splitting the clevis) and have removed the cover at the rear. All good, except when I try to pull the spool out it feels like it hits a hard stop. It seems free around the rubber boot at the front so I expected it to just pull the shaft out of the boot and I could take it out from the rear. Am i missing something? Thanks in advance, Phil</p></blockquote><p></p>
[QUOTE="Phild58, post: 112564, member: 19161"] Hello members, and thank you for the add. I have a question about the seal replacement on the spool valves for a 753F model. I have managed to disconnect the pedal linkage at the front of the valve block (PITA job because the clevis pin was in backwards and I couldn't remove it without splitting the clevis) and have removed the cover at the rear. All good, except when I try to pull the spool out it feels like it hits a hard stop. It seems free around the rubber boot at the front so I expected it to just pull the shaft out of the boot and I could take it out from the rear. Am i missing something? Thanks in advance, Phil [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753F Spool seal replacement question
Top