Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles and first posts only
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753 pump *hums*
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support SkidSteer Forum:
Message
<blockquote data-quote="Tazza" data-source="post: 15864" data-attributes="member: 82"><p>Well, i set the hydrostatic pump(s) to neutral but it still makes the same noise. It still sounds like air in the system, the aux hydraulics couplers were removed and plugs were put on, plus i re-did the tilt ram and hydro motors so air is in there still. The oil is only slightly foamy, you can see small bubbles so i can't rule out air as the problem just yet.</p><p>I couldn't find the cold weather by-pass valve either.... Nothing looked even remotely like the description. The only fittings on the control block were hoses and tube lines. It does have bucket positioning though but i don't know if thats an issue or not.</p><p>The only thing i can do is keep running it a little bit to get the air out and hope it clears up. The only thing i haven't looked at was the hydraulic line from the tank to the pump but my parts break down doesn't show any filters in here.....</p><p>Hopefully I'll figure it out!</p></blockquote><p></p>
[QUOTE="Tazza, post: 15864, member: 82"] Well, i set the hydrostatic pump(s) to neutral but it still makes the same noise. It still sounds like air in the system, the aux hydraulics couplers were removed and plugs were put on, plus i re-did the tilt ram and hydro motors so air is in there still. The oil is only slightly foamy, you can see small bubbles so i can't rule out air as the problem just yet. I couldn't find the cold weather by-pass valve either.... Nothing looked even remotely like the description. The only fittings on the control block were hoses and tube lines. It does have bucket positioning though but i don't know if thats an issue or not. The only thing i can do is keep running it a little bit to get the air out and hope it clears up. The only thing i haven't looked at was the hydraulic line from the tank to the pump but my parts break down doesn't show any filters in here..... Hopefully I'll figure it out! [/QUOTE]
Verification
Post reply
Forums
Bobcat Skidsteer Forums
General Bobcat Skidsteer Forum
753 pump *hums*
Top